Waterway Executive Pump Impeller Wear Ring (1,2 & 3HP)

Waterway Executive Pump Impeller Wear Ring (1,2 & 3HP)

Genuine replacement impeller wear ring for Waterway Executive pump wet ends designed specifically for use with Hot Tubs & Spas. This wear ring is used in conjunction with the 1hp, 2hp and 3hp impellers used on the Executive wet ends. They sit between the rear of the faceplate and the front of the impeller within the pump wet end.

This wear ring prevents water from flowing backwards from this gap and maximum water flow can be produced. Over time these wear rings can wear thin and they can then create a rattling noise when the pump is at high speed.

Product Specifications

• Manufacturer - Waterway Plastics
• Part Number - 319-1380
• Type of Product - Pump Impeller Wear Ring
• Used with Impeller HP - 1/2/3hp
• Outer Diameter  - 85mm
• Height - 28mm

Top Tips

We recommend if you are replacing the impeller inside your hot tub pump wet end to also replace this wear ring and shaft seal kit that seals the rear of the impeller shaft to the wet end rear volute. This will avoid having to strip down your pump again to replace this seal kit in the near future. 

We Are Here To Help!

It can be a bit confusing choosing the correct hot tub parts for your hot tub pump as brand names and models are not always written on them. The quickest way is to simply send us some images of the complete hot tub pump you need the replacement parts for through our Contact us page and let us do the work for you.